Tuning a drum drum is so simple even a drummer can do. And just three easy steps.
1st Take a small pillow in the drum, when one of the heads is the shell.
You do not need a pillow full of Queen or nothing. Only to be big enough cushion to gently, leaning against the drum. This gives you the perfect amount of noise to his powerful attack without a ring or support to give.
2nd Tune front (resonant) is incredibly low.
Yes, it should be just about the tension where it undulates and is to be ugly. Go around the drum construction of a quarter turn on each leg so there is no excessive stress in any location on the drum. It is very important that the height of the head are uniform. Tune to a quarter turn behind the ripple voltage, then press firmly on the center of the head to head. Re melody on quarter-turn voltage ripple again.
3rd Tune the batter head (which you will receive) a major third above the heads of others.
Mount the head than others, after all the previous steps in this regard as well. So, hypothetically, if you make sure it was after before ripple down, then stopped to listen. Now that you’ve done this, mentioned the third major tune up I, so that the two leaders agreed in Nice resonance between them. If your drums or microphone to play live, it will make a big difference.
